Just Cars + Intro to Electronic Control Modules | FLEX Programmer | BIN files and Basics Reverse Class – May 28th @ 8:00am

Description

Just Cars + Intro to Electronic Control Modules | FLEX Programmer | BIN files and Basics Reverse Class

Saturday May 28th 8am-12pm


Description: Engineering Software
Join us and enhance your knowledge in the field of engine control unit (ECU) and automatic transmission (TCU) reprogramming/repair. In this class, you will learn more about the advanced FLEX tool and all functionalities and file services available to manipulate data on ECU/TCU. What is
the difference between Master and Slave Tools. Learn the various programming methods available to read/write control modules. Step by step DEMO reading/writing BMW/GM ECUs.

Second part of this class is an introduction to BIN files, various kinds of memory storage devices, hex editor softwares and how to create modules for various solutions such as ISN change, VIN update and more for future reference, using a special BIN MAP software. This section will give you a better understanding of how BIN files are structured, HEX vs DEC vs BIN vs ASCII, what checksum is and how to compare files and create templates to save time.

INTRO TO ECU + FLEX + BMW/GM ECU DEMO (2 hours)

  • Flex Programming Tool
  • What is an engine control unit, transmission control unit
  • ECU and TCU programming methods with Magicmotorsport tools
  • Usage of Magicmotorsport software
  • OBD, bench, JTAG, BDM, bootloader
  • How to use Magicmotorsport Helpdesk and products
  • BMW/SUPRA MDG1 Bench Read/Write, ISN (DEMO)
  • GM E92 ECU Global A Read/Write/Virginize (DEMO)

Class Cost: $100.00 per participant

Note: A Just Cars 2022 General Admission ticket is required to attend this class.

 

Just Cars + Intro to Electronic Control Modules | FLEX Programmer | BIN files and Basics Reverse Class – May 28th @ 8:00am

$100.00

Sold Out

Category: